KMWE expand additive manufacturing activities

AM for production

AM for Production, the new and annual knowledge and networking event about Additive Manufacturing will take place on 29 March at the Brabanthallen in Den Bosch, The Netherlands.


Lecture Rob van Loon

Our colleague Rob van Loon (Additive Manufacturing Engineer) will be on stage at this AM fair to share his findings. You can join the lecture “Why a Quality Assured process is key for serial production of AM parts”, presented by Rob van Loon (Additive Manufacturing Engineer) on Wednesday 29th  (14:00 – 14:25 uur), Room 1.
More infomation: Program 29 March 2023 | AM for Production. Admission is free.


Article in Solutions Magazine

In the article below, Franc Coenen writes about our steps made in the world of Additive Manufacturing. CEO Edward Voncken explains how KMWE saw the need of AM which results in an expansion for metal printers from SLM Solutions in section G on Brainport Industries Campus (planning Q2 2023). In the same article, Rob van Loon takes a closer look at the production process: “If we think along from the start, it saves headaches in the production process. A small adjustment can save tens of percent on costs”.
Read more in the article below- Solutions Magazine (in Dutch).
Solutions Magazine – 3D Print Magazine – KMWE toont groei-ambities op AM vlak


Registration exhibition and conference

The event is freely accessible. Register for free visit.


<< Back to overview